The article describing the way of holes preparation.
Thanks to that function, a user has a possibility to cut the holes for: cable grommets, speculums, inspection doors and clamping screws.
Holes preparation can be done on any library's element.
As the example, we will present cutting hole in the control door. The cutting starts with setting the elements.
Next, we mark the element, in which the hole has to be cut and choose "Operations" and "Cut a hole".
The available operations are to be seen on the right side of toolbox. The margin and type of the cutting hole can be selected. Below there is a list of new and already existing holes.
Choose the element, in which you would like to cut a hole. Dimensions will be picked automatically.
After choosing the parameter and composition click the OK button.
A moment later, the hole is cut.
Marking the element again and clicking the cutting function you can see existing holes.
Further holes can be added. There is a possibility of cutting few holes at the same time. It is enough to mark more than one composition.
To cut round hole, choose the cylider hole type and cylider orientation parallel to the X. In our example the height of the cylider is parallel to the X.
The hole is cut in the same way as previously.
Each hole can be removed. To remove the hole, choose it from the existing holes' list and click DELETE button or click ight mouse button ->Remove.
After the operation's approval, the hole will be removed.
